Effective Filling: High speed auger provides delivery of product into bag. Optional agitator assists in feed of poor flowing products.
Clean: Auger (and agitator when used) designed to provide minimum aeration of product.
Easy Operation: Empty valve bag is simply placed on filling tube and start signal actuated. Filling, weighing and cut-off at weight are fully automatic.
Compact: Ideal for low head room installations.
Economical: Positive bag opening feature permits use of minimum bag size and improves accuracy.
Precise Weight Control:
Accuracy: ¡À 2 ounce at 2 sigma with optional bulk
and dribble filling for most products.
Electronic Control: Optional premium electronic
weighing system is capable of checking weights on
the packer and feed back of corrections to product
cut-off. Computer compensates for fluctuations in
product density and/or flow.
Patented Weighing Flexure System: No friction system that insures accurate measurement of bag weight.
Strain Gauge Load Cell: Provides the
sensitivity and resolution necessary for
accurate weighing.
Isolated Weighing System: Dual tube design
eliminates random forces from auger rotation.
Bulk & Dribble Filling: This option allows for
precise cut-off of product flow. At the critical cutoff
point, material flow is reduced, thereby
producing better weight accuracy than
conventional systems.
- Powered bag clamp
- Mild steel product contact surfaces
- 900 rpm auger
- Auger alignment without shims
- 3 1/4 OD filling tube
- V hopper for free flowing products (no agitator)
- Stuffing box shaft seals
- Bag chair for support of bag bottom
- Enclosed guards at V belt drive
- Sturdy welded steel frame
- TEFC motor and dust tight electrical controls
- High quality control components
- Sealed proximity switch for cut-off weight sensing
- Electrical controls completely wired and ready for factory power connection
- DM electronic controller
- Dust collection hood and duct assembly
- Bulk and dribble filling
- Premium electronic controller
- Inspection door with interlock switch
- Stainless steel product contact surfaces
- Cone type valve sealer on filling tube
- Hopper with ribbon agitator and rotary paddles
- Motors and electrical enclosures for wet or hazardous environments
- Electrical controls for special voltages
- Auger drive at higher rpm
- Hastalloy auger and filling tube
- Pneumatic powered bag discharge chair
- Automatic bag edge start switch
- Bag discharge delay timer
- Bag clamp coder
- 7.5 or 10 hp drive motor
Bag Capacity:
22 to 110 lbs. (10 to 50 KG.)
Rate:
Up to 4 bags per minute depending upon product density and bag size
Auger Drive:
5 hp, 1800 rpm TEFC motor. Driven speed - 900 rpm
Electrical Power Required:
230/460 V, 3 ph, 60 Hz, 20/10 amps
Electrical Controls:
Disconnect switch, fuses, control transformer, reversing starter, timer(s), push buttons and
lights in dust tight enclosers.
Compressed Air Required: 0.5 scf @ 80 psig per bag packed
Bag Valve Size:
5 1/2 . Minimum - 5 3/4 - 6 suggested for use with valve bag applicator
Bag Length:
Up to 34 long pasted valve multiwall bag
Shipping Weight:
Approximately 1250 lb (595 kg)
